Braun 7526 SyncroPro System - Manual (Page 12)

12
• Slide down the contact bow to connect the shaver
and to start the selected program.
If no program is selected, the default function
«clean» will be started.
• Do not interrupt a running program, as it leaves
the shaver wet and not fit for use. If interruption is
needed nonetheless, press the release button.
• After a program has finished, the corresponding light
will go out. Prior to the next shave, press the release
button to release the shaver.
• When the «cartridge» light starts flashing, the re-
maining fluid in the cartridge is sufficient for approxi-
mately 5 more cleaning cycles. After these 5 cycles,
the cleaning performance will be reduced and the
cartridge has to be replaced.
• When the «cartridge» light illuminates constantly, the
cleaning function is locked and a new cartridge has
to be installed.
Only then, the next cleaning cycle can be started.
• A cleaning cartridge should be sufficient for about
30 cleaning cycles. With daily use, the cleaning
cartridge should be replaced approx. every 4 weeks.
• The hygienic cleaning solution cartridge contains
alcohol which, once opened, will naturally evaporate
slowly into the surrounding air. Each cartridge, if not
used daily, should be replaced after approximately
8 weeks.
• Clean the housing from time to time with a damp
cloth, especially the opening where the shaver rests.
Accessories
Available at your dealer or Braun Service Centers:
Refill cartridge (double pack) CCR 2, (#5331)
Subject to change without notice.
For electric specifications, see printing on the special
cord set.
select
clean
char
ge
cartridge
sele ct
7526
select
7526
5493311_NA7526_S4-38 Seite 12 Mittwoch, 21. September 2005 3:07 15