Braun 7526 SyncroPro System - Manual (Page 6)

6
A Shaver
Your Braun SyncroPro is supplied with a Braun
Clean&Renew™ (please see section B).
SmartLogic
The «SmartLogic» electronics inside your shaver ana-
lyzes your personal shaving patterns, and then adapts
the battery care and cleaning cycles to ensure optimal
performance.
Description
1 Foil protection cap 7 Charging light (green)
2 Shaver foil 8 Low charge light (red)
3 Cutter block 9 Pilot light
4 Foil release button 10 Shaver socket
5 Long hair trimmer 11 Special cord set
6 Switch
Charging the shaver
• First charging: Using the special cord set, connect
the shaver to an electrical outlet with the switch in
position «0» and charge it for at least 4 hours (plug
might get warm).
The SmartLogic inside your shaver automatically
monitors the condition of the batteries as well as the
charging/discharging processes and adapts them to
your personal shaving patterns.
• From now on, the SmartLogic inside your shaver will
ensure optimal care of the batteries. If, for instance,
it is your habit to never let the batteries get low, the
SmartLogic will recognize this, look for a pause
when you are likely to not use the shaver and com-
pletely discharge and then recharge your shaver to
recondition the batteries (every six months at the
most, and only when necessary).
• A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
• Best environmental temperature range for charging
is 60°F to 95°F / 15 °C to 35 °C.
21
0
7540
5493311_NA7526_S4-38 Seite 6 Mittwoch, 21. September 2005 3:07 15