Braun 7526 SyncroPro System - Manual (Page 8)

8
Keeping your shaver in top shape
Automated cleaning
The Braun Clean&Renew™ takes care of all cleaning
and lubrication needs of your shaver. Please refer to the
separate use instructions.
Manual cleaning
For easy cleaning after each shave, switch the shaver
off. Press the release buttons to lift the shaver foil (do
not remove the foil completely). Switch on the shaver
for approx. 5-10 seconds so that the shaved stubbles
can fall out.
For a thorough cleaning (weekly), remove the shaver foil
and tap it out on a flat surface. Using the brush, clean
the cutter block and the inner area of the pivoting head.
If your skin is very dry and you notice a reduced opera-
tion time of the shaver apply a drop of light machine oil
onto the shaver foil.
Replacing the shaving parts
To maintain 100% shaving performance, replace your foil
and cutter block every 18 months or when worn. Change
both parts at the same time for a closer shave with less
skin irritation.
(Shaver foil and cutter block: part No. 7000)
Tips for the perfect shave
• It can take up to 14-21 days for your beard to adjust
to the new shaving system.
• Shave before washing your face or taking a shower,
as skin tends to swell after washing.
• The drier the skin, the closer the shaving results will
be.
• Hold the shaver at right angles (90°) to the skin.
Stretch your skin and shave against the direction of
beard growth.
• To maintain 100% shaving performance replace
your foil and cutterblock every 18 month or when
worn.
oil
10
10
5493311_NA7526_S4-38 Seite 8 Mittwoch, 21. September 2005 3:07 15