Asus V3-M2V890 - Manual (Page 75)

5-17 ASUS V-Series M2V890
5.4.3 Chipset
The Chipset menu allows you to change the advanced chipset settings.
Select an item then press <Enter> to display the sub-menu.
NorthBridge Configuration
Advanced Chipset Settings
Warning: Setting wrong values in below sections
may cause system to malfunction.
Memory Controller
AGP Bridge K8M890 AGP/PCI EXPRESS Configuration
SouthBridge VIA VI8237A Configuration
Hyper Transport Configuration
Memory Controller
Memory Configuration
ECC Configuration
Power Down Control [Auto]
Alternate VID [0.850V]
Memory CLK :333 MHz
CAS Latency(Tcl) :5.0
RAS/CAS Delay(Trcd) :5 CLK
Min Active RAS(Tras) :15 CLK
Row Precharge Time(Trp) :5 CLK
RAS/RAS Delay(Trrd) :3 CLK
Row Cycle (Trc) :21 CLK
Asynchronous Latency :6 ns
Memory Configuration
Memclock Mode [Auto]
MCT Timing Mode [Auto]
Bank Interleaving [Auto]
Enable Clock to All DIMMs [Disabled]
MemClk Tristate C3/ATLVID [Disabled]
Memory Hole Remapping [Disabled]
Memory Configuration
Memclock Mode [Auto]
Allows you to set the memory clock mode.Set by the code using [Auto]
or select [Manual] to set using one of the standard values.
Configuration options: [Auto] [Manual] [Limit]