Asus V2-PH1 - Manual (Page 32)

2-14 Chapter 2: Basic installation
8. Connect the other end of the IDE ribbon cable to the Primary IDE
connector (labeled PRI_IDE) on the motherboard. See page 4-4 for the
location of this connector.
9. Connect the other end of the audio cable to the black 4-pin connector
labeled CD on the motherboard. See page 4-7 for the location of this
connector.
10. Remove the dummy drive slot cover from the front panel.
4
4
3
10. Replace the front panel. Refer to section “2.11 Replacing the side
plates and front cover” on page 2-20 for details.