Asus P1-PH1 - Manual (Page 33)

2-17 ASUS Pundit P1-PH1 system
To install a Serial ATA hard disk drive:
1. Follow steps 1-3 of the previous section.
2. Connect one end of the supplied
7-pin SATA cable to the
connector at the back of the
drive, then connect the other end
to the SATA connector on the motherboard. See page 4-7 for the
location of the Serial ATA connector.
3. For Serial ATA HDDs with a 4-pin power connector:
Connect a 4-pin (female) power plug from the power supply unit
(PSU) to the 4-pin (male) power connector at the back of the drive.
For Serial ATA HDDs without
a 4-pin power connector:
Use the supplied SATA power
cable. Connect a 4-pin plug
(female) from the PSU to the
4-pin (male) plug of the SATA
power cable. Connect the
15-pin SATA power plug to the
power connector at the back of
the drive.
Serial ATA cable
Serial ATA power cable
4-pin (male)
15-pin