Asus Vintage - Manual (Page 48)

4 - 4 4 - 4 4 - 4 4 - 4 4 - 4 C h a p t e r 4 : M o t h e r b o a r d i n f o r m a t i o n C h a p t e r 4 : M o t h e r b o a r d i n f o r m a t i o n C h a p t e r 4 : M o t h e r b o a r d i n f o r m a t i o n C h a p t e r 4 : M o t h e r b o a r d i n f o r m a t i o n C h a p t e r 4 : M o t h e r b o a r d i n f o r m a t i o n
2 . 2 . 2 . 2 . 2 . U S B d e v i c e w a k e - u p ( 3 - p i n U S B P W 1 2 , U S B P W 3 4 , U S B d e v i c e w a k e - u p ( 3 - p i n U S B P W 1 2 , U S B P W 3 4 , U S B d e v i c e w a k e - u p ( 3 - p i n U S B P W 1 2 , U S B P W 3 4 , U S B d e v i c e w a k e - u p ( 3 - p i n U S B P W 1 2 , U S B P W 3 4 , U S B d e v i c e w a k e - u p ( 3 - p i n U S B P W 1 2 , U S B P W 3 4 ,
U S B P W 5 6 )
U S B P W 5 6 ) U S B P W 5 6 ) U S B P W 5 6 ) U S B P W 5 6 )
Set these jumpers to +5V to wake up the computer from S1 sleep
mode (CPU stopped, DRAM refreshed, system running in low power
mode) using the connected USB devices. Set to +5VSB to wake up
from S3 sleep mode (no power to CPU, DRAM in slow refresh, power
supply in reduced power mode). Both jumpers are set to pins 1-2
(+5V) by default because not all computers have the appropriate
power supply to support this feature.
The USBPW_12 and USBPW_34 jumpers are for the rear USB ports.
The USBPW_56 jumper is for the internal USB header that you can
connect to the front USB ports.
• This feature requires a power supply that can provide at least 1A on
the +5VSB lead when these jumpers are set to +5VSB; otherwise,
the system would not power up.
• The total current consumed must NOT exceed the power supply
capability (+5VSB), whether under normal condition or in sleep
mode.
+5V
(Default)
+5VSB
2
1
3
2
USB device wake-up
USBPW12
USBPW34
2 3 2 1
+5V
(Default)
+5VSB
USBPW56