Armasight DAB10X42RF0ARM1 10x42 Binoculars - Manual (Page 10)

10
3.3 INTERPUPILLARY ADjUSTMENT
You must first adjust the binoculars so that each eye piece is adjusted to the distance between your
eyes. This is done by putting the binoculars in both hands and bending it until you can see a single
circular image.
3.4 DIOPTER ADjUSTMENT
To watch the object by handing the binoculars , You will need to close your left eye. Rotate the right di-
opter adjustment rings untill the object image appears sharp and clear in your right eye opening. Then
open you left eye and close right eye, rotate the left diopter adjustment rings untill the object image
appears sharp and clear in your left eye opening. Then can get a perfect viewing.
3.5 RETICLE USING
3.5.1 ARMASIGHT bINOCULARS RANGEFINDER RETICLES
The 7x50C and 8x30C reticle has horizontal scale and vertical scale, in the below there is compass scale
(see Figure 6). Vertical and horizontal lines on the reticule is in mils as unit. Each small division on both
vertical and horizontal lines represents 5 mils and each big division represents 10 mils. You can obtain
the azimuth angle, upper and lower angle, distance and height or width etc. by using this reticle.
Figure 4. Interpupillary Adjustment
Figure 5. Diopter Adjustment