Caution, Connecting the control line to the terminal strip – YSI IQ S ENSOR N ET MIQ/CHV PLUS User Manual
Page 13
MIQ/CHV PLUS
Installation
3 - 3
ba76036e01
01/2012
Connecting the control
line to the terminal strip
Fig. 3-1
Clamping termination for the valve control line
Caution
No free wires must be allowed to project into the enclosure.
Always cut off any wires that are not in use as closely as possible
to the cable gland.
1
Open the module.
2
Screw the cable gland (pos. 1 in Fig. 3-1) with the sealing ring
(pos. 2) into the left connection opening.
3
Loosen the coupling ring (pos. 3 in Fig. 3-1).
4
Feed the valve control line through the left cable gland in the
module housing.
5
Connect the wires of the valve control line (pos. 5 in Fig. 3-1)
to the clamping termination for the valve control line. While
doing so, pay attention to the specifications on the label
located under the terminal strip.
6
Tighten the coupling ring (pos. 3 in Fig. 3-1).
X6
X5
X4
SENSORNET 2
RED
SHIELD
GREEN
X3
X2
X1
SENSORNET 1
RED
SHIELD
GREEN
ON
OFF
SN
TERMINA
TO
R
Valve
X7
X8
Valve
1
3
2
4
5