Bell & Gossett V1000187C Circuit Setter Plus Calibrated Balance Valves – Lead-Free - Manual (Page 6)

Insulation
Bell & Gossett recommends that insulation be attached to the Circuit Setter after the system has been balanced and the
completed G95872 tag has been wired to the Circuit Setter.
NOTE: Tape or other acceptable means should be used to secure the insulation to the Circuit Setter balance valve.
B&G Circuit Setter correction factors for viscosity and specific gravity
Xylem Inc.
8200 N. Austin Avenue
Morton Grove, Illinois 60053
Phone: (847) 966-3700
Fax: (847) 965-8379
www.xyleminc.com/brands/bellgossett
Bell & Gossett is a trademark of Xylem Inc. or one of its subsidiaries.
Loctite and Loctite 567 are registered trademarks of Henkel AG & Co. RectorSeal No. 5 is a registered trademark of
RectorSeal Corporation.
7. Properly assembled valve components will immediately seal to moderate pressure (100 PSI or less). For maximum
pressure resistance, allow the Loctite 567 or Rector Seal No. 5 thread sealant to cure for 24 hours. PTFE tape typically
does not require curing to achieve maximum pressure resistance.
© 2013 Xylem Inc. V1000187C July 2013
Bell & Gossett is a trademark of Xylem Inc. or one of its subsidiaries.