West Control Solutions MRC 5000 Controller Manual - Manual (Page 6)

6
Section 2 Installation and Wiring
Read these instructions completely and carefully before proceeding with the installation and operation of this recorder.
Electrical code requirements and safety standards should be observed. Installation should be performed by qualified person-
nel only.
Caution: The standard recorder will accept a power input over the range of 90-264 VAC. There is a special low power
voltage option that is available. Please verify the AC input power required by the recorder before proceeding with the
installation. The power required is listed in the Model/Serial number label affixed to the platen in the upper left hand
corner.
2.1 UNPACKING
Remove the recorder from the carton and inspect for any damage due to shipment. If any damage is noted, report and file a
claim with the carrier. Write the model number and serial number of the instrument on the inside front cover of this operation
manual for future reference.
2.2 LOCATION / MOUNTING
Locate the instrument away from excessive moisture, oil, dust and vibration. Do not subject the instrument to operating
temperatures outside of the 0 to 55
°
C (32 to 131
°
F) range.
The panel where the instrument will be mounted must provide rigid support for the approximate 7 lb. weight of the instrument.
Adjacent instruments may be mounted within a minimum of 2 inches horizontally and 3 inches vertically, providing that proper
panel support is provided.
PANEL MOUNTING:
1. Remove the mounting brackets attached to the recorder upon receipt.
2. Cut panel opening to the dimensions illustrated in Figure 2-1A.
3. Insert the recorder in the panel opening. Reattach the mounting brackets to the side of the recorder with the mounting ears
facing the back of the panel. Adjust the mounting brackets so they fit snugly against the panel, and then tighten.
PANEL MOUNTING HARDWARE REQUIRED: (provided with instrument)
(1) set mounting brackets - mounted to the recorder
(1) set mounting screws - mounted to the recorder
FIGURE 2-1A
±
0.06
±
0.06