Updating firmware, Downloading and installing firmware loader – Extron Electronics CTR 8 User Guide User Manual
Page 15
CTR 8 • Updating Firmware
10
Updating
Firmware
Updates to the CTR 8 firmware are released periodically on the Extron website. You can find
which version is currently loaded on your CTR 8 using SIS commands. Compare this with the
latest release on the Extron website and decide whether to update your firmware.
TIP: Read the Release Notes provided on the website with the latest firmware to
determine whether you need the latest version.
This section covers the following:
z
Downloading and Installing Firmware Loader
z
z
Installing Firmware with Firmware Loader
Downloading and Installing Firmware Loader
Extron recommends using the Firmware Loader software to update the firmware on Extron
products. If you do not already have Firmware Loader installed on your computer, download it as
follows:
1.
Go to the Extr
Download link.
2.
Click the Software link on the left sidebar menu.
3.
On the Download Center page, locate Firmware Loader and click its Download link.
Figure 7.
Firmware Loader Download Link
4.
On the next screen, enter the requested information, then click the Download
fw_loader_vnxnxn.exe button (where n is the Firmware Loader version number).
5.
Follow the instructions on the rest of the download screens to save the executable Firmware
Loader installer file to your computer. Note the location to which the file was saved.
6.
In Windows Explorer or another file browser, locate the downloaded executable installer file
and double-click to open it.
7.
Follow the instructions on the Installation Wizard screens to install Firmware Loader on your
computer. Unless you specify otherwise, the installer program places the Firmware Loader
file, FWLoader.exe, at c:\Program Files\Extron\FWLoader.