Extron Electronics DXP HDMI User Guide - Manual (Page 108)

DXP DVI Pro and DXP HDMI Series • Matrix Software 102
3. Using a rotating motion of the screwdriver, carefully pry the two pieces apart (see c
in figure 102).
4. Lift out the transparent square label that you want to replace, being careful not to
damage the circuits beneath it. You may need to use the small screwdriver to gently
pry the label out.
5. Insert one of the new labels you created in before starting into the clear button cap,
align the white backing plate with the cap, and firmly snap it into place.
6. Gently, but firmly, press the reassembled button into place on the DXP front panel.
7. Repeat steps 1 through 6 as needed to relabel other buttons.