Extron Electronics DXP HDMI User Guide - Manual (Page 27)

DXP DVI Pro and DXP HDMI Series • Operation 21
Example 2: Adding a Tie to a Set of Video Ties
In the following example, a new tie is added to the current configuration. The illustrations
show the front panel indications that result from your actions.
NOTE: This example assumes that you have performed example 1.
1. Press and release the Esc > button.
C O N T R O L
PRESET ENTER ESC VIEW
Press the Esc button to clear all selections.
The button blinks once.
Figure 18. Clear All Selections
2. To select only video for the tie, press and release the Video and Audio buttons as
necessary until the Video button is lit and the Audio button is off.
I / O
AUDIO VIDEO
Press the Video button to toggle video on.
The button lights green when selected.
Press the Audio button to toggle audio off.
The button is
unlit or background illuminated when deselected.
Figure 19. Select Video Only
3. Press and release the Input 5 button.
1 2 3 4 6 7 8
Press and release the Input 5 button.
The button lights
green to indicate that video
outputs can be tied to or untied from this input.
INPUTS
1 2 5 6 7
OUTPUT
The Output 3, Output 4, and Output 8 buttons
light green
to indicate the video ties created in
example 1.
5
3 4 8
Figure 20. Select an Input with Ties
4. Press and release the Output 1 button.
2 5 6 7
ESC VIEW
CONTROL
8 3 1
Press and release the Output 1 button.
The button blinks
green to indicate that the
selected video input will be tied to this output.
The Enter button blinks
green to indicate the need to
confirm the change.
OUTPUT
4
ENTER PRESET
Figure 21. Select an Additional Output