Extron Electronics Matrix 50 Series - Manual (Page 26)

Operation, cont’d
Matrix 50 Series Switchers • Operation 3-6
C Press and release the input 5 button. The input 5 LED lights.
D Press and release the output 3, output 4, and output 8 buttons. The output
3, output 4, and output 8 LEDs blink to indicate a tentative tie.
The entire set of ties can be canceled at this point by pressing and releasing
the Esc button. The Esc LED flashes once.
E Press and release the Enter button. The input and output LEDs turn off.
The current configuration is now defined as video and audio input 5 tied to
video and audio output 3, output 4, and output 8.
Example 2: Adding a tie to a set of video and audio ties
See figure 3-4 and the following steps for an example in which a new video tie is
added to the current configuration on a 12x8 Matrix 50 switcher with audio.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC
ESC
VIDEO AUDIO
VIDEO
12
8
CONTROL I/O
A
B
ENTER
E
C C
1
3 8 4
5
C
D
B
B
F
LED key: = off, = on, = blinking,
= flash once F
Press
Press
Press
Press
Press
Figure 3-4 — Example 2: Adding a video tie
A Press and release the Esc button. The Esc LED flashes once.
B To select video only for the tie, if necessary, press and release the Video and
Audio buttons until the Video LED lights and the Audio LED is off.
C Press and release the input 5 button. The input 5 LED lights. If the steps in
Example 1 have been completed, the output 3, output 4, and output 8 LEDs
light to indicate ties created in Example 1.
D Press and release the output 1 button. The output 1 LED blinks to indicate
a tentative tie.
E Press and release the Enter button. The input and output LEDs turn off.
The current configuration is now video input 5 tied to video output 1,
output 3, output 4, and output 8; and audio input 5 tied to audio output 3,
output 4, and output 8.
Example 3: Removing a tie from a set of video and audio ties
See figure 3-5 and figure 3-6 and the following steps for an example in which an
existing audio tie is removed from the current configuration on a 12x8 Matrix 50
switcher with audio.
A Press and release the Esc button. The Esc LED flashes once.
B To select audio only for the tie, if necessary, press and release the Video and
Audio buttons until the Video LED is off and the Audio LED lights.