Operation, cont’d, Matrix 50 series switchers • operation 3-8 – Extron Electronics Matrix 50 Series User Manual
Page 28
Operation, cont’d
Matrix 50 Series Switchers • Operation
3-8
2
.
Press and release the View button.
3
.
Select video, audio, or both to view by pressing the Video and/or Audio
buttons.
4
.
Select the desired input or output(s) for which ties need to be viewed by
pressing the input and output buttons.
1.
To see all ties of the current configuration, press and release each input
and output button, one at a time, with the Video and Audio LEDs on.
2.
In view-only mode, you can view video and audio, video-only, or audio-
only ties. Pressing and releasing the Video and Audio buttons toggles
each on and off.
3.
If, when you view video and audio ties, the Audio LED blinks and the
Video LED is on after you select an input or output, the LEDs indicate
that the audio ties are not the same as the video ties for that input (audio
breakaway is active). Toggle the Video LED off by pressing and
releasing the Video button.
4.
When you enter view-only mode, the output LEDs turn on for all
outputs without ties. Likewise, when an output button for which there
are no ties is pushed, the output LEDs turn on for all outputs without
ties. The blinking Audio LED indicates audio breakaway for one or
more of those outputs.
Example 4: Viewing video and audio, audio only, and video only ties
See figure 3-7, figure 3-8, figure 3-9, and figure 3-10 and the following steps for an
example of viewing the video and audio, audio-only, and video-only ties in the
current configuration on a 12x8 Matrix 50 switcher with audio.
Example 4 shows the process of viewing the current configuration after the
steps in Examples 1, 2, and 3 have been completed.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8
9
10
11
PRESET VIEW
ESC
ESC
VIDEO AUDIO
VIEW
12
8
CONTROL
I/O
A
B
C
VIDEO
AUDIO
C
F
2
7
6
5
LED key: = off, = on,
= flash once
F
Press
Press
Press
Press
Figure 3-7 — Example 4: Viewing the current configuration
A
Press and release the Esc button. The Esc LED flashes once.
B
Press and release the View button to enter view-only mode. The View LED
lights.
C
To select both video and audio for viewing, if necessary, press and release
the Video and Audio buttons until the Video LED and Audio LED light.
With no input LED selected, all output LEDs that have no established ties
light.