Extron Electronics Matrix 50 Series - Manual (Page 3)

QS-1
Quick Start — Matrix 50 Series Switchers
Installation
Step 1
Mount the switcher in a rack.
Step 2
Turn off power to the input and output devices,
and remove the power cords from them.
Step 3
Cable the switcher for RGsB, RsGsBs, HDTV/
component video, S-video, or composite video
input and output (3).
Step 4
Cable audio models for stereo audio input. Each
input has a 3.5 mm, 5-pole captive screw
connector for balanced or unbalanced stereo
audio (4). High impedance is generally over
800 ohms.
Step 5
Cable audio models for stereo audio output.
Each output has a 3.5 mm, 5-pole captive screw
connector that outputs the selected unamplified,
line level audio. Connect an audio device, such
as an audio amplifier or powered speakers (5).
Step 6
If desired, connect a control system or computer
to the Remote RS-232/RS-422 port (6).
Step 7
If desired, attach an external sync timing device
to the external sync connectors (7).
Step 8
Plug the switcher and input and output devices
into a grounded AC source, and turn on the
input and output devices.
Definitions
Tie — An input-to-output connection.
Set of ties — An input tied to 2 or more outputs.
(An output can never be tied to multiple inputs.)
Configuration — One or more ties or sets of ties.
Current configuration — The currently active
configuration (also called configuration 0).
Global preset — A configuration that has been
stored. One preset can be assigned to each input
button. When a preset is retrieved from memory,
it becomes the current configuration.
Unbalanced Input
Tip
Sleeve
Tip
Sleeve
Balanced Input
Tip
Ring
Sleeve (s)
Tip
Ring
Tip
Ring
Sleeve (s)
Tip
Ring
Balanced Input
(high impedance)
(high impedance)
(600 ohms)
600 ohms
600 ohms
4
A
UDIO
A
UDIO
Unbalanced Output
Tip
See caution
Sleeve
Tip
See caution
Balanced Output
Tip
Ring
Sleeve (s)
Tip
Ring
5
HDTV
Composite
video S-video
3
6
Female
5 1
9 6
Male
1 5
6 9
RS-232 Function Pin
1
2
3
4
5
6
7
8
9 —
TX
RX
—
Gnd
—
—
—
—
Not used
Transmit data
Receive data
Not used
Signal ground
Not used
Not used
Not used
Not used
RS-422 Function
TX-
TX+
RX+
RX-
Gnd
—
—
—
—
Transmit data (-)
Transmit data (+)
Receive data (+)
Receive data (-)
Signal ground
Not used
Not used
Not used
Not used
7
Timing source Matrix 50 switcher
OUT
To next device
CAUTION Connect the
sleeve to ground.
Connecting the
sleeve to a
negative (-)
terminal will
damage the audio
output circuits.