Extron Electronics IPL T PC1i Setup Guide - Manual (Page 19)

IPL T PC1 Interface • Software Setup
Software Setup, cont’d
3-14 IPL T PC1 Interface • Software Setup 3-15
5 . Create a group folder for your output device functions:
a . Click the Add folder icon ( ) above the
GlobalViewer ® Web Group(s) section. A folder icon
with the name Group Folder appears in the tree
window.
b . Give this folder a name, preferably the name of the
device for which you added the driver in step 4.
6 . Select IR driver functions for your output device:
a
. Make sure that the folder you added in the Web
Group(s) section is highlighted.
b . In the IR Driver Function(s) (left) section, click on one
or more functions that you will want to monitor and/
or schedule on the output device. (To select multiple
functions, hold down the Ctrl key while clicking on
each function name.)
7 . Click the green right-arrow button at the right of the IR
Driver Functions section. The functions you selected are
listed below the selected folder in the GlobalViewer ® Web
Group(s) section.
Assigning an IR driver
To assign a device driver to the IR port,
1
. In the IP Link tree view area, click on an IR port name.
The IR Configuration tab is displayed.
2 . In the IR Driver Selection field, select a device type,
manufacturer, and Version from the drop-down boxes.
3 . Select an available driver.
4 . Click Add Driver.