Extron Electronics MTPX Plus 6400 Series Setup Guide - Manual (Page 23)

3. Click Finish to exit the wizard.
NOTE: You may need to repeat these steps if you
subsequently connect the switcher to a different USB
port on the same computer.
Starting the Program
1. Click Start > Programs > Extron Electronics > Matrix
Switchers > MATRIX Switcher + Control Pgm.
The Comm Port Selection window appears.
2. Choose the comm (serial) port that is connected to the switcher,
USB, or IP [LAN].
NOTE: For a comm port, check the baud
rate displayed in the Comm Port
Selection window. If you need
to change the baud rate, click the
Baud button and double-click the
desired baud rate.
Click OK.
If you selected a serial port or the USB port in step 2, the Matrix
Switchers Control Program is ready for operation.
3. If you selected IP [LAN] in step 2, the IP Connection window
appears.
a. Examine the Matrix IP Address field, which displays the
last Matrix IP address entered.
If necessary, enter the correct IP address in the field.
NOTE: 192.168.254.254 is the factory-specified default
value for this field.
b. If the switcher is password-protected, enter the appropriate
administrator or user password in the Password field.
c. Click Connect. The Matrix Switchers Control Program is ready
for operation.
Optimizing the Video
Each TP input has a level and peaking adjustment. Most MTP
transmitters and half of the MTPX Plus TP outputs have a pre-peaking
feature. TP inputs and outputs have skew adjustments. See the
following sections to set these adjustable features.
NOTE: Unless the TP cables are changed, these adjustments
should need to be made only once, during installation.
Before you start optimizing, set all input level and peaking, input and
output skew, and ouput pre-peak settings to either zero or off.
Setting the MTP transmitter Pre-Peak feature
For inputs from MTP T 15HD products only — If the cable between
the MTP transmitter and the MTPX Plus is 300 feet (91 m) or longer,
turn on the Pre-Peak switch on the transmitter. For shorter cables,
turn the switch off.
36 MTPX Plus 6400 • Remote Control and Optimizing the Video 37 MTPX Plus 6400 • Remote Control and Optimizing the Video