Extron Electronics SW HDMI LC User Guide - Manual (Page 26)

SW HDMI LC • Remote Communication and Control 20
8. Click Add to add your switcher name to the Firmware Loader screen. The Add Device
window closes, leaving the Firmware Loader window open with your SW HDMI LC
name highlighted and selected in the Devices field.
Figure 17. Firmware Loader Screen with an SW HDMI LC Added
or
Click Add Next if you want to upload firmware to multiple Extron devices at the same
time (they do not all have to be SW HDMI LC switchers). Your switcher is added to the
Firmware Loader screen and the Add Device window remains open. Continue with the
following procedure:
a. Select or enter the information for your next device in the Identify Target Device
field, and click Connect.
b. Browse to locate and select the firmware file to be uploaded to the new device.
c. If you intend to add more devices to the Firmware Loader, click Add Next. If
finished adding devices, skip to step e.
d. Repeat steps a through c for each device that you want to add to the Firmware
Loader.
e. When finished adding devices, click Add for your last device, or click Cancel to
close the Add Device window.
9. Click Begin to start the uploading process.
While the firmware is being updated, a progress bar in the Total Progress field shows
the status of the upload, while the Transfer Time field displays the time elapsed and
the time remaining in the process. In addition, the percent of the file that has been
uploaded is displayed highlighted in the Progress column until the entire firmware file
is uploaded.