Extron Electronics System 5cr Plus - Manual (Page 24)

Setup and Operation, cont’d
System 5cccccrrrrr Plus • Setup and Operation 3-4
Setting Up the System 5cccccrrrrr Plus
The System 5cr Plus must be set up (configured) before it can control other
equipment. Setup can be done from the front panel, or from a computer using the
provided control software. Setup cannot be done via the IR 401 remote control or
the SCP 100P control pad.
Extron provides preset configurations in the form of projector driver files that can
be downloaded from diskette or the Extron website. See “Downloading and using
projector drivers” in chapter 4 for details. Projector drivers assign projector IR
commands to the System 5’s front panel controls so that the display power, mute,
and mode functions can be used to control the projector.
Configuring the System 5cccccrrrrr Plus from the front panel
The System 5 must be in the setup (config) mode during setup. The Config LED
lights when the setup mode is on. The following configuration procedures can be
performed from within setup mode:
• clear an individual button’s IR function configurations,
• clear all System 5 settings,
• set audio input attenuation levels,
• select video formats,
• initiate IR learning.
See the flowcharts in this section for the specific steps for setting up the System 5.
When there has been no activity for at least 20 seconds, the System 5 times out
from the setup mode to the normal mode, and the Tx, Config, and Retry LEDs
will all flash for 5 seconds.
Clearing configurations
Clearing configuration settings resets them to factory defaults. To clear
configurations, see the flowchart below.
Press and hold all 3 DISPLAY buttons
together for 2 seconds.
Normal Mode
CONFIG LED lights
Setup
(Config)
Mode
At any point after entering
the Setup mode, you can
Configure any feature in any order,
or
Wait 20 seconds to time out to Normal mode.
Press and hold
all 3 DISPLAY buttons
together for 2 seconds
to return to Normal Mode.
or
Wait 20 seconds
for the System 5 to
time out to Normal Mode.
Press the ROOM button twice.
The ROOM LED blinks for 8 seconds.
During that time, do one of the following:
Press any desired front panel button to clear & reset only that button's IR configuration.
or
Press all 3 DISPLAY buttons at the same time for 2 seconds to
clear and reset
all System 5 settings.
TX
CONFIG
RETRY
ROOM
DISPLAY
POWER MUTE MODE
DISPLAY
POWER MUTE MODE
VID
Y/C
VID
PC
Y/C
VID
Y/C
ROOM PC1 PC2 INPUT3 VID1 VID2
Pressing all three Display buttons clears and resets all configuration settings
to the factory defaults. These settings include Display functions, IR commands,
room settings, video type, RGB delay, power up/down delay, room relay mode,
audio gain, and all other settings.