Extron Electronics System 5cr Plus - Manual (Page 5)

Press and hold all 3 DISPLAY buttons
together for 2 seconds.
Press the ROOM button twice.
The ROOM LED blinks for 8 seconds.
During that time, do one of the following:
Press any desired front panel button to clear & reset only that button's IR configuration.
or
Press all 3 DISPLAY buttons at the same time for 2 seconds to clear and reset
all System 5 settings.
Normal Mode
CONFIG LED lights
Setup
(Config)
Mode
With an active audio signal present,
press an input's button twice in quick succession
to adjust its audio input. The input's LED blinks.
Press the input's
button once to
save. Repeat for
each audio input. Turn VOLUME knob up (clockwise)
until CLIP LED is on or blinking fast. Turn VOLUME knob
down (counter-clockwise)
until the CLIP LED is off or
blinks occasionally as
the level peaks.
Press and hold the ROOM button
while setting video formats.
Press INPUT3 to toggle between
video formats for that input (an LED
lights to indicate the selected format).
Repeat for VID1 and VID2
Release
the ROOM
button
Point the projector's IR remote
control at the System 5's
IR LEARN port and firmly press
the desired button on the remote.
Press the
DISPLAY POWER,
MUTE, or MODE
button & hold it
for 2 seconds.
CONFIG LED lights steadly while
TX & RETRY LEDs flash to indicate
that the signal has been learned.
If the TX LED is off and the
RETRY LED blinks once, press the
POWER, MUTE, or MODE button
and the IR remote's button again.
For POWER button configuration,
if the TX LED is off and both the
CONFIG and RETRY LEDs blink,
the System 5 is ready to
learn the power-off signal.
Press the System 5's POWER
button twice in quick succession,
then aim the remote and press the
IR remote's power button again.
Repeat all steps for each
DISPLAY button to be learned.
CONFIG LED blinks
At any point after entering
the setup mode, you can
Configure
any of the features described here,
in any order,
or
Wait 20 seconds to time out to Normal mode.
Press and hold
all 3 DISPLAY buttons
together for 2 seconds
to return to Normal Mode.
or
Wait 20 seconds
for the System 5 to
time out to Normal Mode.
Setting
audio input
attenuation
levels
Initiating
IR learning
Clearing button
configurations
Selecting
video formats
TX
CONFIG
RETRY
ROOM
DISPLAY
POWER MUTE MODE
DISPLAY
POWER MUTE MODE
VID
MAX.
CLIP
MIN. Y/C
VID
PC
Y/C
VID
Y/C
PC1 PC2 INPUT3
VOLUME
AUDIO
VID1 VID2
VID
Y/C
VID
PC
Y/C
VID
Y/C
ROOM
DISPLAY
POWER MUTE MODE PC1 PC2 INPUT3 VID1 VID2
TX
CONFIG
RETRY
TX
CONFIG
RETRY
or
TX
CONFIG
RETRY
or
TX
CONFIG
RETRY
TX RX LEARN
CONFIG
RETRY
COMPUTER AUDIO
PC1 INPUT IR
PLUS SYSTEM 5
VID
Y/C
VID
PC
Y/C
VID
Y/C
ROOM PC1 PC2 INPUT3 VID1 VID2
1 2 3
4 5 6
7 8
0
9
Setup (Configuration) Procedure