Braun OC15525 OxyJet 3D Center - Manual (Page 10)

10
The Braun Oral-B OxyJet™ 3D Center has been
developed together with leading dental professionals to
effectively remove plaque from all areas of your teeth and
to attack plaque bacteria.
The Braun Oral-B 3 D Plaque Remover adds a gentle
pulsating movement to its oscillation to create a deep-
cleaning 3 D brushing action. The plaque remover should
be used twice a day for at least two minutes, the minimum
brushing time recommended by dental professionals.
The Braun Oral-B OxyJet™ irrigator mixes air into water
in the form of micro-bubbles. These micro-bubbles in the
water stream attack plaque bacteria.
At the same time, it removes remaining food particles from
between your teeth and massages your gums. Always use
the irrigator after brushing your teeth.
Please read the use instructions carefully before first use.
Important
The plug should always be accessible.
Periodically check the cord for damage. Should this be
the case, take the appliance to a Braun Service Centre.
A damaged or non-functioning unit should no longer be
used.
Description
Plaque remover
1 Charging base
2 Charge indicator
3 Plaque remover handle (rechargeable)
4 Switch
5 Brushhead
6 Brushhead compartment
Irrigator
7 Jet compartment
8 Irrigator jet
9 Jet switch
0 Jet release button
q On/off switch
w Water pressure control dial
e Sliding switch (water stop and go)
r Irrigator handle
t Water container ( 600 ml / 20 f l. oz.)
Specifications
Power supply: see bottom of housing
Power intake: 24 W
English
4715119_ OC15X_P4-96 Seite 10 Mittwoch, 11. Oktober 2000 7:31 07