Braun OC15525 OxyJet 3D Center - Manual (Page 11)

11
Using the plaque remover
Connecting and charging
Plug the appliance into an electrical outlet. Place the
handle
3 on the charging base 1 , the charge indicator
will light up.
A full charge will take 16 hours and will provide
45 minutes operation time. For everyday use, the handle
can be stored on the charging base to maintain it at full
power. Overcharging is impossible.
Battery maintenance
To maintain the maximum capacity of the rechargeable
battery, the following procedure should be done every
6 months : Do not place the handle back onto the
charging base in order to discharge it by regular use.
Once discharged, recharge the handle on the charging
base.
Operating the switch
Press the switch 4 to operate the plaque remover, press
again to stop it.
The «deluxe» models OC 15 525 X and OC 15 545 X
additionally feature a reduced speed setting for sensitive
areas of the mouth:
Press the switch to operate with normal speed,
press a second time to operate with reduced speed,
press a third time to switch the handle off.
Removing plaque
The plaque remover can be used with any leading brand
of toothpaste. However, we do not recommend
toothpastes with whitening agents.
To avoid splashing, guide the brushhead to your teeth
before switching the handle on.
Guide the brushhead from tooth to tooth, following the
curve of the gum and the shape of each tooth. Hold the
brushhead in place for a few seconds before moving on
to the next tooth. Brush the gums as well as the teeth.
Do not press too hard nor scrub – simply let the brush do
all the work.
During the first few days of using the plaque remover,
your gums may bleed slightly. In general, bleeding should
stop after a few days. Should it persist after 2 weeks,
please consult your dentist or hygienist.
O ral-B
O ral-B O ra l-B
+1x 1x
on +1x
off
O r al-B
4715119_ OC15X_P4-96 Seite 11 Mittwoch, 11. Oktober 2000 7:31 07