Andrew James AJ000229 Ultimate 7 Litre Food Mixer Package - Manual (Page 9)

9
Inserting the attachment
1. Lift up the front end shield.
2. Holding the head, insert it into the inlet.
3. Rotate the head in the same direction until a small sound can be
heard. Try to gently rock the head to ensure it is firmly secured in the
correct position.
4. Place the meat dish on the appliance in the appropriate place.
5. Place the food screw into the head, long end first by turning the feed
screw slightly until it is set into the motor housing.
6. Place the cutting blade onto the feed screw shaft with the blade
facing the front as illustrated. If it is not fitted properly then the meat
will not grind correctly.
7. Place the desired cutting plate next to the cutting blade, fitting
protrusions into the slots.
8. Support or press the centre of the cutting plate with one finger then
screw the fixing ring until it is tight with the other hand, do not over
tighten it.
9. Place the hopper plate on the head and fix it into position.
10. Place the unit on a flat, level and sturdy place.
11. The air passage at the bottom and the side of the motor housing
should be kept free and unblocked.