IMP Pumps NMT(D) SMART (C) - Manual (Page 17)

-17-
GB
5. Setup and operation
5.1. Control panel
1 Bar display of values
2 Numerical display of values
3 Unit display of the currently selected
parameter
4 Display of the currently selected mode
5 key
6 key
7 key
5.2. Switching the pump on and off
When the pump is connected to the network for the first time, it operates with
the factory settings in automatic mode.
With subsequent start-ups, the pump will operate with the last settings that
were set prior to its shut-down.
To switch the pump off, press and hold the key for 5 seconds, until OFF is
shown on the display. When the pump is switched off, the numerical display
shows OFF.
To turn the pump on, press the key briefly.
5.3. Pump functions
Key
Short press:
• Scrolling through parameters downwards when not changing parameter values,
• Scrolling through modes downwards when mode selection is selected,
• Changing parameters downwards when setting parameter values.
Long press:
• 3 seconds together with key to select night mode,
• 5 seconds to switch off the pump,
• 5 seconds together with and keys to restore pump to factory settings.