AAEON PFM-C20N User Manual
Page 30
Advertising
C AN B u s M o d u l e
P F M - C 2 0 N
Chapter 3 Driver Installation
3 - 5
The setting of Base Address has to be the same as Jumper
setting.
IRQ only support POLLING.
The Baud Rates of Transmit Port and Monitor Port have to be the
same.
For Mode, you may choose “Basic” or “Peli” (only Peli can transmit
“Extended frame”). The default setting of “Mode” is “Basic.”
The Acceptance Code and Mask will be varied by the “Mode” you
set. For example, “Basic” is 8 bits, Peli is 32 bits. You may
choose the default setting if the application has no specific request.
You may click on “OK” after finish setting these values.
Advertising