AAEON PFM-C20N User Manual
Page 42
C AN B u s M o d u l e
P F M - C 2 0 N
Chapter 3 Driver Installation
3 - 17
Step 8: Testing by using different platforms
Using the two boards to test the transmitting and receiving. For
example, the can0 of GENE-5315 is the Monitor Port, and the can0
of EPIC-8526 will be the Transmit Port. Or the can1 of EPIC-8526 is
the Monitor Port, and the can0 of GENE-5315 is the Transmit Port.
In addition, you may use different systems. One is DOS system
and the other one is Windows system, or one is DOS system and the
other one is Linux system to test the transmitting and receiving
(make sure the Baud Rate setting is the same).
Step 9: Change the setting to test.
After testing, you may want to change the IRQ or Baud Rate for a
further testing. Please follow the steps below to activate.
9-1 Uninstall the driver
[root@localhost Fedora5]# /sbin/rmmod can.ko
9-2 Modify the setting based as the Step 3
9-3 Install the driver again
[root@localhost Fedora5]# make load