ABUS FU8007 Secvest 2WAY Base Kit Installation - Manual (Page 70)

70
Batt Load Test Used for activating the battery test function.
Siren in PSet Used for controlling the siren properties with an internally
activated system.
Force Set Used for activating and deactivating the Force Set function
or activating it with a confirmation.
RF Siren Options Used for setting the response of the wireless siren.
17.1 User access
Select the corresponding options for the user from the table. To activate a function for
the User, press Change.
The option must be set to “Y” in order for it to be used.
Function Meaning
Record Voice Memo Enables the user to record a voice message.
Reset After Alarm Enables the user to reset the wireless alarm centre
following an alarm using the user code. When “N” is
selected, the user can only set the alarm to silent. The
installer must reset the system by entering the user code.
Every user can reset the dual key function.
Dual key function Activates the alarm buttons on the keypad for the user.
Zone Tamper Reset Enables the user to reset the wireless alarm centre with
the user code following a tamper alarm. When “N” is
selected, the user can only set the alarm to silent. The
installer must reset the system by entering the user code.
Omit All Enables the user to lock all open zones simultaneously
with a single button.
Social Care Key Activates the “Social Care” key on the keypad for the
user.
Quick set Enables the activation of the alarm centre without a user
code.
Switching 2WAY
Replies on / off Installer Menu Æ System Options Æ User Access Æ 2
Way Replies Æ Y/N
x“Y” (yes) is the default factory setting.
xWhen “N” (no) is selected, no feedback is sent to
the FU8100 wireless remote control, FU8110
wireless control unit and FU59xx Secvest Key
2WAY wireless cylinder.
17.2 Remote control / remote access by telephone
This function enables a user to give commands to the wireless alarm centre from a
remote location using the telephone keypad. The available commands are as follows.
More information can be found in the operating manual. There are two possibilities
here:
Call-out control
When set to Y, the user can control the system remotely when answering a call from
the wireless alarm centre.
When set to N, the user can still use the remote commands for the voice dialler, but
not the remote control options.
Call-in control
When set to Y, the user can call the wireless alarm centre remotely. A user can send
commands using the telephone keypad after identifying themselves to the wireless
alarm centre with an access code.
Function Input
Deactivate system #0*0
Activate system #0*1
Activate system internally #0*2
Disable sirens #1*0
Reset system #1*1
Query system #3*
Switch ON output nn #9*nn*1
Switch OFF output nn #9*nn*0
Switch output nn #9*nn*
When “Call-in control” is set to “Y”, the wireless alarm centre does not
answer any incoming calls from the downloader.