Aeromotive 11108 - MARINE A1000 FUEL PUMP - Manual (Page 2)

The enclosed Aeromotive fuel pump utilizes AN-10 ORB (O-ring Boss Ports) style inlet and outlet ports;
these ports are NOT PIPE THREAD and utilize NO THREAD SEALANT.
Compatible Fuels:
Pump Gas
Race Gas
E85
Diesel
Alcohol/Ethanol
The following steps are typical of most installations:
1. Referring to the appropriate vehicle service manual for instructions, remove the OEM fuel pump.
2. Install an after-market sumped high flow capacity fuel tank or fuel cell, per the manufacturer’s
instructions.
3. Find a suitable place on the vehicle chassis to mount the fuel pump. Make sure the location will
accommodate the pump mounting bolts. Make sure to position the pump at or below the bottom of
the tank. Make sure that the pump is clear of the exhaust, is clear of any moving suspension or
drivetrain components and will keep the pump clear of road obstructions or debris.
4. Using the enclosed template, mark and drill four mounting holes to accept ¼” bolts. Mount the fuel
pump using four ¼” bolts, nuts and lock washers. For quieter fuel pump operation use Aeromotive
p/n 11601 fuel pump vibration dampening mounting kit.
Note: Be sure to route all fuel lines clear of any moving suspension or drive train components,
and any exhaust components! Protect fuel lines from abrasion and road obstructions or debris.
5. Using minimum of 9/16” ID or AN-10 fuel line, connect the fuel tank sump outlet to a 12304 fuel
filter. Using the same size fuel line connect the fuel filter outlet to the fuel pump inlet, or if you are
using an Aeromotive fuel filter you can attached the filter directly to the fuel pump utilizing an AN-10
fitting (15608) and 2 sealing o-rings (10AN o-ring pack 15623).
Note: It is recommended that a fuel shut off valve be installed between the fuel tank outlet and
the fuel pump. Use Aeromotive part # 12331 shutoff valve fuel filter and 15640 swivel fitting to
make the connection.