Aeromotive 11108 - MARINE A1000 FUEL PUMP - Manual (Page 6)

Aeromotive, Inc. Technical Bulletin #101
From:
Aeromotive Technical Department
Date: 10/10/2011
Re: Fuel Filtration: Selecting the correct filter to prevent lean-out and pump failure.
STOP!! If you are selling or installing a fuel filter on the inlet of an Aeromotive fuel pump, be
certain you do not use a filter that causes more problems than it solves. For pump inlet
filtration, use only Aeromotive 100-micron P/N #12304, #12302 or an acceptable equivalent
(see specifications below). Do not install the Aeromotive P/N #12301 or 12310 filter with 10-
micron fabric element on the inlet of any Aeromotive fuel pump, they are however perfect for
use on the outlet of the pump, and this is the only location for which they are recommended.
You may run any brand of filter you choose on your car, just be certain that it meets the following
requirements: The filter element used on the inlet side of any Aeromotive fuel pump may be no
finer than 100-micron (no number smaller than 100), with a surface area of 60 square inches or
more.