Aeromotive 18673 - A1000 CAMARO STEALTH KIT - Manual (Page 3)

FIGURE 1-1
9. Support the rearend (complete IRS sub frame) with a suitable jack (transmission jack works best). Remove the four
24mm bolts that hold the sub frame in. Carefully lower the rearend, paying close attention to the brake lines on each
side of the frame. There is enough length on the brake lines to get the tank out without removing the calipers. Once
lowered, support the complete IRS sub frame with jackstands.
10. Remove the evap canister. This is done by unplugging all hoses and wires and removing the two 10mm bolts.
11. Unplug and remove the wiring harness connection at the tank on the passenger side.
12. Remove the fuel tank strap mounting bolts (15mm), tank straps and drop the tank out of the car. NOTE: It’s
recommend to do this with two people.
13. Now remove the pressure feed line and pressure sensor. Also remove the lock ring holding the fuel pump module in
place. NOTE: The fuel pump module is spring loaded and will pop up. FIGURE 1-2
FIGURE 1-2