Alpha Technologies AlphaGen PN-6x-T 7.5kW 48VDC - Technical Manual - Manual (Page 41)

042-288-B0-001, Rev. A 41
3.0 Installation, continued
3.4 Enclosure Grounding, CE-3x2 5K-T
Run the chassis and earth grounding wires through the one-inch opening in the bottom of
the generator enclosure. Using a 7/16" nutdriver or socket, secure the ground leads to the
grounding stud located on the enclosure wall. See Fig. 3-12 below.
It is the responsibilty of the system installer to verify applicable grounding requirements, and to ensure that
system grounding complies with all state, local, or regional requirements.
ATTENTION:
Fig. 3-12, Enclosure Grounding, CE-3x2 5K-T