Alpha Technologies Cordex CXPS-M 48_24-1200_600A - Manual (Page 50)

9400004-J0 Rev B 48
Figure 34 —
Insulation cover (rear view)
Cut between the holes
with side cutters to make a
large enough entryway for
the required cables. Figure
33 shows a small hole cut
in the cover.
Make a straight cut to the
back edge of the cover,
so the cover can be fitted
around the cables when
replacing it at the end of the
installation.
Reinstall the top cover.
6.8.3 Top Cover(s)
6.8.2 Installing the battery cable insulation covers
Insulation cover kits, #0380060-001 are included with the initial shipment of the equipment—two kits for each
bay.
STEP 1
1. Start from the rear left and wrap an insulating cover around the cables and bus bar (refer to Figure 34 and
Figure 35).
2. Secure with the plastic pins.
Figure 33 —
Top Kydex cover with cuts for cable entry