Antex Electronics DMX8 USB Mixer - Manual (Page 6)

Installing the DMX8 USB Mixer
Before commencing an installation make sure you have the following:
ƒ DMX8 USB Mixer
ƒ DMX8 USB Mixer CD or Software downloaded from www.fortherecord.com
ƒ DMX8 USB Mixer Installation Guide (this guide)
ƒ Hi-Speed rated USB cable to connect DMX8 USB Mixer to computer (supplied)
ƒ Power cable suitable for your region (supplied)
ƒ Microphones
ƒ Microphone cables wired correctly for the DMX8 XLR connectors
Voltage Selection
Before connecting the equipment to mains power, be sure to select the correct
operating voltage for your region.
1. Remove the power cable from the equipment.
2. Slide the voltage selector switch located under the power inlet socket to the correct
setting.
3. Check that the required voltage is now visible on the voltage selector switch.
4. Re-insert the power cable.
Location
The DMX8 USB Mixer can be mounted on a tray in a 19” rack or placed on a shelf or
table. All connections are from the rear panel (see Appendix A Diagram 1).
Ideally the DMX8 USB Mixer should be located inside the room where recording will
take place however it can be located outside if due consideration is given to microphone
and output cable lengths and electrical interference.
The DMX8 USB Mixer must be located close to the computer it is connected to. Hi-
Speed USB has a connection length limit of 16 feet (5 meters).
Page 2