Atec Keithley-2290-5 - Manual (Page 3)

Model 2290-5 High Voltage Power Supply Characteristics
Specifications are subject to change without notice.
SPEC-2290-5 Rev. A / December 2013
Page 3 of 3
External voltage set
Input scale: 0 to +10 V for 0 to full scale
Input impdance: 1 M
Ω
Accuracy: ±0.2% of full scale
Update rate: 16 Hz
Output slew rate
5, 6
: <(Rise time + 0.3 seconds) for 0 to full range under full load
GENERAL:
Input power: 55 watts
2290-5 Input voltage: 120 V ±10%, 50 or 60 Hz
2290E-5 Input voltage: 240 V ±10%, 50 or 60 Hz
2290J-5 Input voltage: 100 V ±10%, 50 or 60 Hz
Rear panel connectors:
SHV male (Kings type 1704-1 or equivalent)
Output high-voltage connector GPIB connector
BNC Connector (two): Voltage set/Voltage monitor; Current monitor
Toggle switch: Voltage setting or Voltage monitor
High-voltage safety interlock:
Connector: 3-pin press-in connector, 3M part number: 37103-A165-00E-MB
Pin 1: 5 V nominal out, 1.5 mA maximum out
Pin 2: Input: High-voltage output enabled: 3 – 24 V DC
High-voltage output disabled: <1.2 V DC or open connection
Pin 3: Chassis ground through a 100
Ω resistor
Interface protocol: IEEE-488.1
Operating environment: 0º C to 40º C; non-condensing
Dimensions: 89 mm high x 206 mm wide x 406 mm deep (3.5 in x 8.1 in x 16 in)
Weight: 5.5 kg (12 pounds)
Safety: Conformance to European Union low voltage directive
Warranty: One year
Warm-up time: One hour