atwood EDWIN RV Entry Door Window - Manual

EDWIN Installation Guide
Installing the Entry Door Window (a.k.a. EDWIN) in your RV is easier than you might
think. First timers should plan on 30-45 minutes to complete the EDWIN installation.
To make this as easy as possible, we have provided step-by-step instructions for this
Do-it-yourself project.
Tools needed. Your new Atwood EDWIN window is shipped with
all the parts you need for a complete installation: Window and
Frame, Interior Trim Ring, Screws and Flange Seal Tape. The only
tool you will need is a Screw Gun and Putty Knife.
Step 1. Remove the old door window.
•
Remove all the screws around the perimeter of the old
door window frame from inside the vehicle. There will be
approximately 16 screws . (See photo A)
•
Once all screws are removed, the inner trim ring can be set
aside and the window can now be pushed out of its open-
ing (See photo B). It is recommended that a second person
stand outside with a hand lightly on the window to pre-
vent the window from falling to the ground.
•
If the window is still firmly in place after all screws are re-
moved, you can break the seal by sliding a thin putty knife
under the exterior of the window flange and work your
way around the window until loose. (See photo C)
•
Once the old window is successfully removed, carefully re-
move any remaining sealant or tape that is stuck to the
outside wall at the window opening.
A
B
C