Avision AV880C - Manual (Page 10)

2-3
Refit the shipping retainer:
Whenever you need to transport the scanner, please follow the
instructions below:
1. Turn off the scanner.
2. Raise the document cover. You can see clearly the flatbed
glass as well as the reading engine.
3. Turn on the scanner. At this moment, the reading engine will
move a few inches forward and stay there for a few seconds.
Turn off the scanner during this pause.
4. Raise the scanner high enough to unscrew the shipping retainer
from the “use position” and fix it in the “shipping position.”
SCSI ID:
When you have several devices on a SCSI chain, you may need to
adjust the SCSI ID selector setting located on the back of the
scanner(See Figure 2-3). This setting assigns a specific "device ID"
to the scanner. If the ID number is duplicate with an existing SCSI
device, please select a new ID.
Note: The factory setting for the scanner is ID# 6. Usually, ID# 0 is
assigned to an internal hard disk drive, and ID# 7, to SCSI adapter or
host. ID# 8 and #9 are not in use actual.
Setting Terminator
The scanner is equipped with a built-in terminator switch on the rear
of the scanner. (See Figure 2-3) Turn the terminator switch on if
the scanner is to be connected to the computer as the only or the
last SCSI device. Turn the terminator switch off if the scanner is to
be located between the computer and other SCSI device.