Avision AV6240 - Manual (Page 11)

2-4
2.2 Installation of the SCSI Card
2.2.1 Hardware Installation
The hardware installation of SCSI card is quite simple, just follow the
following procedure:
(1) Power off your computer.
(2) Plug the SCSI card in an available slot of your computer. Be
sure to screw it firmly.
(3) Power on your computer.
The color image scanner bundled with SCSI card is designed to
operate with its default setting in most ISA-class PCs.
SCSI ID:
When you have several devices on a SCSI chain, you may need
to adjust the SCSI ID selector setting located on the back of the
scanner. This setting assigns a specific "device ID" to the
scanner. If the assignment conflicts with an existing SCSI
device, please select a new ID. (See Figure 2-4)
Note: The factory setting for Avision AV6240 scanner is ID 6.
Usually, ID 0 is assigned to an internal hard disk drive,
and ID 7, to SCSI adapter or host. ID 8 and 9 are not in
actual use.