Avision IS15 (FS-0913B) - Manual (Page 11)

3.1 Initial setup
1. Connect the plug on the power adapter cable to the power connector on
the scanner.
2. Plug the power adapter into a power outlet. Wait until the indicator light
on the scanner stops blinking and stays on steady, indicating the scanner
is ready.
3. Insert a memory card into the memory card slot or a flash disk into the
flash disk slot. (If you install a memory card and a flash disk to the
product at the same time, the scanned image will be stored in the
memory card.)
Insert a flash disk into the flash disk slot.
Insert a memory card into the memory card slot.
3-2