Avision IS15 (FS-0913B) - Manual (Page 12)

3.2 Scan an original
1. Insert your photo into the plastic sheath supplied with the scanner.
(The detailed usage of the plastic sheath is described in the next page.)
2. With the side to be scanned facing upward and in correct orientation,
place the left edge of the original against the left edge of the feeding slot.
3. Simply let go the original when it begins to feed into the slot.
4. When the scan is completed, the scanner will automatically create a folder
titled “Photo1” on your memory card or flash card, which will hold the
first 9999 scans. Then “Photo2” folder will be created for the next 9999
scans, and so on.
(Each scanned image is given a file name with the prefix img followed by
a 4- digit sequential number in the order the images are stored. For
example,
img0001.jpg
, img0002.jpg, etc.)
Note:
• Do not remove the memory card or disconnect the power supply while the
indicators are blinking.
• This scanner only supports output images in JPEG (.jpg) format.
• If the memory card is near full (lower than 1MB), the indicator light blinks.
Use another card or delete some files on it if necessary.
• Insert only one original at a time, and insert the next original only when the
previous one is done and the blinking has stopped, otherwise the scanner
may malfunction.
• Remove the things remained on the photo, such as staples, paper clips, and
paper sticky notes before feeding it into the scanner due to possible
damage to the scanner.
3-3