B&K Precision 879B - Manual - Manual (Page 48)

46
display shows “ dEF”, either press or
button to change the setting so that the secondary
display shows “ yES”. Upon saving and exiting the
utility menu, the instrument will automatically reset
back to its original settings. Below is a table of all the
settings that will be restored.
Table 3 - Instrument Default Settings
Settings Default Configuration
Primary Function C (Capacitance)
Secondary Function None
Measurement Method SER (Series)
Test Frequency 1 kHz
Beep On
Auto Power-off 15 (15 minutes)
Power-up State PrE
Reset Default Settings No
Note: In the case where under “PuP” option, “SEt” is
selected and “ dEF” is set to “yES”, the “PuP” setting
has priority over the “ dEF” setting. This means the
instrument will not be set back to default upon saving
and exiting the utility menu. Instead, the power-up
settings will be stored and will be recalled upon the
next power-up of the instrument.