BlueBird CL550A - Manual (Page 22)

22
STORAGE
To ready the machine for storage, follow these
steps:
1. Clean the machine carefully, particularly the
chassis and working equipment. Mend damage
to the paint to prevent rust.
2. Inspect the machine for worn or damaged parts
and tighten any nuts or bolts that may have
become loose.
3. Change the engine oil; dispose of properly.
4. Open the fuel valve. Empty the fuel tank (1)
and the carburetor (2).
Winter storage
At the end of the season, the machine should be
readied for storage (or if it will not be in use for
longer than 30 days). Fuel allowed to stand for long
periods of time (30 days or more) can leave sticky
residues that can plug the carburetor and disrupt
engine function.
Fuel stabilizers are an acceptable option to
reducing sticky residues during storage. If alkylate
gasoline (Aspen) is used, stabilizers are
unnecessary because this fuel is stable. However,
you should avoid switching between regular and
alkylate gasoline as sensitive rubber components
can harden. Add stabilizer to the fuel in the tank or
in the storage container. Always use the mixing
ratios specified by the manufacturer of the
stabilizer. Run the engine for at least 10 minutes
after adding the stabilizer so that it reaches the
carburetor. Do not empty the fuel tank and the
carburetor if you have added stabilizer.
WARNING!
Never store an engine with fuel in the
tank indoors or in poorly ventilated
spaces where fuel vapor can come in
contact with open flame, sparks or a
pilot light such as in a boiler, hot water
tank, clothing dryer, etc.
Handle the fuel with caution. It is very
flammable and careless use can cause
serious damage to person and
property. Drain the fuel into an
approved container outdoors and far
away from open flame. Never use
gasoline for cleaning. Use a degreaser
and warm water instead.
7. Lubricate all grease zerks, joints and chains
as described in the chapter ”Lubrication/
Lubrication schedule”.
8. Store the machine in a clean, dry place and
cover it for extra protection.
5. Close the fuel valve.
6. Remove the spark plug and pour about a
tablespoon of engine oil in the cylinder. Turn
over the engine so that the oil is evenly
distributed and then refit the spark plug.
Put the engine in the compression phase where
the triangle mark on the sleeve of the starter is
aligned with the upper hole in the starter.
Note: Compression phase occurs every second
revolution.
Service
When ordering spare parts, please specify the
purchase year, model, type, and serial number.
The chain on this unit is a high quality permalube
type. DO NOT replace with a simple roller chain.
Oil chain and sprockets per lube schedule.
Always use genuine BlueBird spare parts.
An annual check-up at an authorized service
workshop is a good way to ensure that your
machine performs its best the following season.
8011-048
8011-049