Brown Products EdgeMaster (E-104H, E-104H5.5) - Manual (Page 10)

PAGE 6
3. START ENGINE
A. Be sure belt tensioner is in disengaged position and that no tension
is on the belt.
B. Turn ignition to “ON” position.
C. Close choke if engine is cold.
D. Pull start cord rapidly.
E. As the engine warms, gradually move the choke lever to the
“OPEN” position.
WARNING: Do not operate the machine until area is cleared of
people, pets, automobiles, etc. that might be damaged
by projectiles.
WARNING! Do not operate machine without blade guard in place.
WARNING! Operator must wear eye protection when operating the
Edge Master
tm
. (Eye goggles are provided with each
machine.)
4. ENGAGE BLADE / SET CUTTING DEPTH
CAUTION! Blade will begin to turn when the belt tensioner lever is
moved forward.
A. Move belt tensioner lever forward to tighten belt and set cutting
depth.
B. Insert locking pin into appropriate hole for desired cutting depth.
5. ADJUST CURB HEIGHT
CAUTION! adjust curb height before starting engine.
A. Place left rear tire of edger on the curb.
B. Loosen adjustment handle on front wheel assembly and right rear
wheel assembly.
C. Lift edger frame to level position by pushing the handle to the left
until frame is level.
D. Re-tighten wheel adjusting handles (The edger will work on curbs
up to 10” high.)
E. Proceed with operating procedures.