Brown Products BrushOx (BC2613HER) - Manual (Page 30)

30
Assembly Instructions (con’t)
9. Attach forward and reverse control assembly to right handlebar, as shown in
Illustration D (Below).
Illustration D
10. Now that all control levers and cables are installed, remove the Rear Frame
Closure Plate (Part # 260-257) and use Illustration E (Following Page) to assure
proper Blade Engagement Cable adjustment. The Clutch Activation Lever should
be against the internal forward stop and the Blade Engagement Lever (Part # 260-
002) on the left handlebar should be in the full up position. There should be
virtually no slack in the Blade Engagement Cable between the lower bulk head
fitting and the Clutch Activation Lever and there should be no cable spring
tension on the Clutch Activation lever. If slack is present, adjust the lower bulk
head fitting to remove the slack in the cable. With the Blade Engagement Lever
(Part #260-002) in the full down position, the Clutch Activation Lever should
travel 1-5/8” toward the rear of the machine and the spring on the end of the
Blade Engagement Cable should expand from 2-3/8” (relaxed) to 3.00” in length.
These two dimensions are critical for the Clutch to properly engage and disengage
and prevent clutch slippage during operation and therefore premature Clutch
failure. All cables should be lightly lubricated daily during operation. Replace
Rear Frame Closure Plate.