BatteryMINDer 24041-AA - Manual (Page 16)

Rev. B-020907 P/N VDC24041AA-MNL
BatteryMINDer ® Model 24041-AA
Page 16
Detailed Operation Instructions Model 24041-AA
After carefully reading and understanding the
Safety Instructions contained in this manual
(pages  to 7) and having evaluated your battery
as described in Qualifying Your Battery (pages 8 to
11) you are properly prepared to begin using your
charger.
1. Attach output cord of charger to either the
Battery Clip(s) Assembly (BCA) (supplied) or the
Ring Terminal Assembly (RTA) (supplied) depend-
ing on your preference. However never use both
assemblies at the same time for any reason what-
soever.
Never use either of these assemblies on any
other charger or for any other purpose such
as improvised “jumper cables”, etc.
Using the RTA on batteries remaining in their nor-
mal use location (in same place they are regularly
installed will normally prove the safest and most
convenient. If you have several applications you
may wish to purchase additional Ring Terminal
Assemblies (RTA) available from your dealer or
VDC Electronics, Inc. directly.
Note: this assembly contains a 15 Amp auto-
motive type fuse and is replaceable should
for any reason it were to blow. Never replace
this fuse with any type whose rating is higher
than 15 Amps, as seriously harmful results
may occur.
2. Identify the positive and negative posts or
connections on your battery, usually clearly des-
ignated with the polarity markings of + (positive)
and – (negative). If you have previously installed
the RTA referred to in 1. above, you need only to
press the connector plug of the charger’s output
cord into the mating plug of the RTA. Push firmly
and do not leave any space between them.