BatteryMINDer 24041-AA - Manual (Page 7)

Rev. B-020907 P/N VDC24041AA-MNL
BatteryMINDer ® Model 24041-AA
Page 7
Do not connect clip to carburetor, fuel lines,
or sheet metal body parts.
Connect to heavy
gauge metal part of frame or engine.
h. When disconnecting charger, disconnect char-
ger from AC outlet, then remove clips from vehicle
chassis, and battery posts.
Operating instructions for charge information.
FOLLOW THESE STEPS WHEN BATTERY IS
OUTSIDE OF AIRCRAFT OR EQUIPMENT.
A SPARK NEAR THE BATTERY MAY CAUSE
BATTERY EXPLOSION. TO REDUCE RISK OF
A SPARK NEAR BATTERY:
a. Check polarity of battery posts. POSITIVE
(POS,P,+) usually has a large diameter than
NEGATIVE (NEG, N, -) battery post.
b. Connect (
RED ) charger clip to (POS+) post of
battery.
c. Position yourself and free end of cable as
far away from battery as possible, then connect
NEGATIVE (
BLACK) charger clip to free end of
cable.
d. Do not face battery when making final con-
nections.
e. When disconnecting charger, always do so
in reverse sequence of connecting procedure
and break first connection while as far away from
battery as practical.
Do not attempt to per-
manently install any charger not specifically
designed for permanent installation, espe-
cially in a wet / marine environment