Camco D-Power 7 - Manual (Page 12)

D - P O W E R
S E R I E S
USER MANUAL
D-POWER 7
P.11
3.2 On/Off Switch
The On/Off Switch is a rocker-type switch. It is located on the right side
of the front panel. To turn the amplifier on, press on the upper part of the
switch. During power up the Clip and Signal LEDs from both channels will
light up in red for a few seconds. To turn the amplifier off, press on the
lower part of the switch.
Amplifier is switched on Amplifier is switched off
NOTE: This switch does NOT disconnect the amplifier from mains.
Make sure the mains power socket or an alternative disconnect device
is nearby and easily accessible.
The switch initiates start-up by activating the inrush current limiter. As soon
as the power amplifier is connected to the mains power supply, a vol tage is
supplied to both the line-filter and the fused input of the controllable recti-
fier. Disconnecting the amplifier from the main power supply can only be
achieved by physically separating the amplifier from the mains by pulling
the mains plug. The mains plug therefore has to be freely accessible. Dis-
connect the mains plug from the mains during a lightning storm or when
the amplifier remains unused or unsupervised for a prolonged period of
time. Alternatively, you can disconnect the amplifier via an external all-pole
disconnection from the mains.
If a power cut occurs while the amplifier is switched on, it will restart auto-
mati cally once the power supply has been restored. All amplifier settings
prior to the loss of power will be maintained.
3.3 Mounting
Use four screws and washers when mounting the amplifier to the front rack
rails. For mobile use, the amplifier should also be secured using the 19”
mounting elements on the rear panel.
44
3,
00
m
m
442,00 mm
483,00 mm
45
2, 00
m
m
465,00 mm
10,50 mm
7,
50
m
m
76
,2
0
m
m 3 INST
ALLA
TION