I-View DM-5MIPN30 5-Megapixels IR Vandal Proof Dome IP Camera - Manual (Page 24)

24
Chapter 3. Running IP Camera by Witness Pro NVR software.
3-1.
Network Deployment
General Connection (without PoE)
1. Connect RJ45 Ethernet cable to a switch. Use a Category 5 Cross Cable when your network
camera is directly connected to PC.
2. Connect the power cable from the Network Camera to a power outlet.
3. If you have external devices such as sensors and alarms, make the connection from the general
I/O terminal block
Power over Ethernet (PoE)
The Network Camera is PoE-compliant, allowing transmission of power and data via a single
Ethernet cable. Follow the above illustration to connect the Network Camera to a PoE-enabled
switch via Ethernet cable.