I-View DM-5MIPN30 5-Megapixels IR Vandal Proof Dome IP Camera - Manual (Page 37)

37
IP Property: Click this button to modify the current Internet protocol with IPv4 or IPv6, IP
address, enable/disable DHCP and DNS IP address. The settings must be properly
configured before you operate the IP camera over network. IPv4 and IPv6 are both
supported. Configure the NIC settings, including the IPv4 (IPv6) Address, IPv4(IPv6)
Subnet Mask and IPv4(IPv6) Default Gateway. Click Save to change the setting.
1.
If the DHCP server is available, you can check to automatically obtain an IP address and
other network settings from that server.
2.
The valid value range of Maximum Transmission Unit (MTU) is 500 ~ 9676.
3.
The Multicast sends a stream to the multicast group address and allows multiple clients
to acquire the stream at the same time by requesting a copy from the multicast group
address.
4.
Before utilizing this function, you have to enable the Multicast function of your router
and configure the gateway of the network speed dome.
5.
If the DNS server settings are required for some applications (e.g., sending email), you
should properly configure the Preferred DNS Server and Alternate DNS server.
6.
The router must support the route advertisement function if you select Route
Advertisement as the IPv6 mode.
PPPoE: If you have no router but only a modem, you can use Point-to-Point Protocol over
Ethernet (PPPoE) function Click this button to enable the PPPoE function, Enter User Name,
Password, and IP address for PPPoE access, then Save to change the setting and exit the
interface.